![]() ![]() Sterilization can only be confirmed by testing for the survival of spores after a complete cycle in the autoclave.If any of the above shortcuts are being taken because the autoclave cannot keep up with your demand, it is time toĮither increase your inventory of handpieces and/or instruments, or get a second autoclave, or an autoclave that processes them faster. Shortening the cycle endangers everyone, so don’t do it.The normal processing cycle varies somewhat by the autoclave manufacturer. ![]() ![]() Is The Cycle Being Allowed To Run For The Right Amount Of Time?.If pressure cannot be maintained within the recommended range, check the troubleshooting guides on this site for your unit.Inadequate Pressure: The chamber pressure should be maintaining approximately 30psi (or manufacturer specifications).Is The Right Amount Of Pressure Being Reached & Maintained?.Guides on this site for the section for your make & model autoclave If the temperature varies widely or the unit cannot maintain the manufacturer recommended temperature look for troubleshooting.Check the temperature periodically during the cycle to make sure the temperature is not fluctuating more than a couple of degrees.Set the temperature control knob so that it reaches and maintains 270° (or manufacturers specifications).Is The Right Temperature Being Achieved & Maintained? Inadequate Temperature:.Refer to the manufacturers specifications and make sure the technician is not putting in too many items at one time. Observe the technician who is responsible for sterilizing the handpieces and/or instruments and look for the If your autoclave has failed a spore test, this is a good time to review your sterilization procedures with your The most common reason for failing a spore test is not due to mechanical failure, but is actually due to operator error. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |